Download The LOOK^® Operational Instructions (.pdf)

Step 1: Open the rear doors or end flap.

Step 2: When backing into a loading dock, release the tension at the rear of the system and push the rear car slightly forward as not to damage the rear car.

Step 3: Always release the tension from the rear locking mechanism first, specifically when the system is equipped with front ratchets. This prevents stress and cracking along the bottom of the Bulkhead securing plate.

Step 4: To open the system from the front or rear, push from either side while on the ground or from the trailer deck level.

Step 5: To close the system secure the front locking mechanism first and tension the system to the rear. A system with ratchets on the bulkhead must first be tensioned at the top, then the bottom. Make sure the front D-Foam on the bulkhead is intact to ensure a proper weather seal. The flat bar guide plates must align the front car to the bulkhead. The four rubber bumpers must be in place to ensure the D-Foam is not fully compressed.

Step 6: To re-set the tarpaulin tension, always ensure the lower exterior cable is loosened first before adjusting the rear locking mechanism. The lower cable should be re-tensioned as the cable provides for maximum weather protection, eliminating the need for cumbersome rubber straps. All models 2007 and newer, require no adjustments to plastic cable (cable is self adjusting).

Step 7: Never drive with the system open or unsecured at the front and rear.

Step 8: Eliminate any obstructions that will hinder the safe operation of The LOOK^®

Note: Failing to operate the system correctly will reduce the overall performance of The LOOK^®

Safety Warnings